top of page

This motor driver board is designed for motors which operation voltages are up to 24V. Driver has two channel and delivers 2A current per channel. L298N motor driver IC is used on board. Board can be used at various motor control implementations like sumo, mini sumo and line follower robots.
 


Board provides step motor control too. For detailed information, you can view example document which is shown in below:

Features :
Board can control two motors seperately.
Deliver 2A current per channel.
Internal regulator is available.
High temperature and shortcut protection is avaliable.
LEds, which light according motor direction, are available.
Internal cooler is available.
Current sense pins are available as emitted.
Four screw holes are available at four sides of board.
 
Pin Mapping:
ENA: Pin is used for left motor activation
IN1: Left motor 1. input
IN2: Left motor 2. input
IN3: Right motor 1. input
IN4: Right motor 2. input
ENB: Pins is used for motor channel activation
MotorA: Left motor output
MotorB: Right motor output
VCC: Supply voltage input(4.8V-24V)
GND: Ground connection
5V: 5V output
 
Jumper plugged pins are available on the board. These pins can be used for optional usages and activate different properties.
CSA: Current output of A motor driver. With a jumper, current draw value can be read as anlog voltage value.
CSB: Current output of B motor driver. With a jumper, current draw value can be read as anlog voltage value.
V1 is a jumper plugged to the pull-up resistor which sends IN1 input to 5V directly. Through this, as you don't plug it to ground, pin voltage level stays as 5V.
V1 is a jumper plugged to the pull-up resistor which sends IN2 input to 5V directly. Through this, as you don't plug it to ground, pin voltage level stays as 5V.
V1 is a jumper plugged to the pull-up resistor which sends IN3 input to 5V directly. Through this, as you don't plug it to ground, pin voltage level stays as 5V.
V1 is a jumper plugged to the pull-up resistor which sends IN4 input to 5V directly. Through this, as you don't plug it to ground, pin voltage level stays as 5V.
5V-EN jumper activates or deactivates 7805 line. If it's plugged 5v output of board becomes active . If it's unplugged this line becomes deactive.

L298N Pair Motor Driver Board with Voltage Regulator |لوحة القيادة ومنظم جهد

25,00₺Price
    bottom of page